Airfix 1/72 A-4C Skyhawk

The Skyhawk is a great little kit,as we’ve become accustomed to from Airfix. Detail is refined with a slightly pebbled surface that looks good under paint. The kit goes together very well with little need for filler. Below you can see the detail on the engine fan face and the engine exhaust… which is buried very far inside the fuselage.

I painted the fan and exhaust silver and gave them a quick wash of Oil paint lamp black thinned with lighter fluid. The lighter fluid dries quick and allows one to move on quickly.IMG_0672-0

I opted to close the speed brakes since unless they are under maintenance, they are usually closed on the ground. Here you can see the fine fit of the parts.IMG_0673-0

Here you can see the fit of the intakes to the fuselage sides. I would say this is the worst fit to be found in the entire kit. The parts needed some careful clean up and there was still a small at the rear of the intake.IMG_0674-0

I took care of the gap with some Vallejo Plastic filler. This is a great tool and made quick work of the gap .IMG_0675-0

The cockpit was nicely detailed and the kit decals were more than sufficient to represent the instrument panels. I applied a thin wash of oil paint to subdue the bright white on the panels. I also used a Pavla resin ejection seat since I had one on hand. The kit seat looks great though too. The Pavla seat did sit a little high in the cockpit though and precludes closing the canopy.IMG_0676-0



Once the fuselage was glued together, the cockpit was masked to spray the IP deck. In fact, I normally spray my entire model black for priming purposes and to start the panel shading.IMG_0679-0

The drop tanks are a little mis-shappen in the middle, but I didn’t bother to try and fix them… under the wing it’s hard to tell there is an issue with them.IMG_0680-0

The TER came from an Academy F-8 Crusader kit. I triedto vary the color of the ordnance for a little variety.IMG_0681

Another shot so that you can tell just how well detailed this kit is… these are the main wheels before the oil wash is applied. IMG_0682

The kit decals went down well with some setting solution. The vortex generators provide an extra obstacle for them to lay down over. IMG_0683

Once the decals were mostly down, I touched up where the decal had torn around the vortex generators.IMG_0684

Images below of the completed kit. I highly recommend picking one up for a relaxing build.IMG_0685















Published by


Scale Modeler on the move

2 thoughts on “Airfix 1/72 A-4C Skyhawk”

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s